Configuring Location Tlv And Location Service - Cisco Catalyst 4500 Series Configuration Manual

Release ios xe 3.3.0sg and ios 15.1(1)sg
Hide thumbs Also See for Catalyst 4500 Series:
Table of Contents

Advertisement

Configuring LLDP and LLDP-MED, and Location Service
Command
Step 3
Switch(config-if)# lldp tlv-select
power-management
Step 4
Switch(config-if)# end
Step 5
Switch# copy running-config
startup-config
This example shows how to enable LLDP power negotiation on interface Gigabit Ethernet 3/1:
Switch# config t
Enter configuration commands, one per line.
Switch(config)# int gi 3/1
Switch(config-if)# lldp tlv-select power-management

Configuring Location TLV and Location Service

To configure location information for an end-point and to apply it to an interface, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# location {admin-tag
string | civic-location identifier id |
elin-location string identifier id}
Step 3
Switch(config-civic)# exit
Step 4
Switch(config)# interface interface-id
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
29-12
Chapter 29
Purpose
Enables LLDP power negotiation.
Returns to privileged EXEC mode.
(Optional) Saves your entries in the configuration file.
End with CNTL/Z.
Purpose
Enters global configuration mode.
Specifies the location information for an endpoint.
admin-tag—Specify an administrative tag or site information.
civic-location—Specify civic location information.
The civic location identifier in the LLDP-MED TLV is
Note
limited to 250 bytes or less. To avoid receiving error
messages regarding available buffer space during switch
configuration, never allow the total length of all civic location
information specified for each civic-location identifier to
exceed 250 bytes.
elin-location—Specify emergency location information (ELIN).
identifier id—Specify the ID for the civic location.
string—Specify the site or location information in alphanumeric
format.
Returns to global configuration mode.
Specifies the interface on which you are configuring the location
information, and enter interface configuration mode.
Configuring LLDP, LLDP-MED, and Location Service
OL-25340-01

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents