Cisco Catalyst 4500 Series Configuration Manual page 901

Chapter 40 Configuring Quality of Service
Example 4
The following command shows how to display policy-map statistics on all VLANs configured on Gigabit
Ethernet interface 6/1:
Switch# show policy-map interface gigabitEthernet 6/1
GigabitEthernet6/1 vlan 20
Service-policy input: p1
GigabitEthernet6/1 vlan 300
Service-policy output: p2
GigabitEthernet6/1 vlan 301
Service-policy output: p2
OL-25340-01
conformed 0 bytes; actions:
transmit
exceeded 0 bytes; actions:
drop
conformed 0000 bps, exceed 0000 bps
Class-map: class-default (match-any)
0 packets
Match: any
Class-map: c1 (match-all)
0 packets
Match: cos 1
Match: access-group 100
police:
cir 100000000 bps, bc 3125000 bytes
conformed 0 bytes; actions:
transmit
exceeded 0 bytes; actions:
drop
conformed 0000 bps, exceed 0000 bps
Class-map: class-default (match-any)
0 packets
Match: any
Class-map: c1 (match-all)
0 packets
Match: cos 1
Match: access-group 100
QoS Set
dscp 50
police:
cir 200000000 bps, bc 6250000 bytes
conformed 0 bytes; actions:
transmit
exceeded 0 bytes; actions:
drop
conformed 0000 bps, exceed 0000 bps
Class-map: class-default (match-any)
0 packets
Match: any
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
Configuring QoS
40-37