Cisco-Desktop - Cisco Catalyst 4500 Series Configuration Manual

Chapter 18 Configuring SmartPort Macros

cisco-desktop

This example shows how to use the system-defined macro cisco-desktop to assign a value of 35 to the
access VLAN of the Fast Ethernet interface 2/9.
Note This macro requires the $AVID keyword, which is the access VLAN of the port.
Switch(config)# interface fastethernet2/9
Switch(config-if)# macro apply cisco-desktop $AVID 35
Switch(config-if)# end
Switch# show parser macro name cisco-desktop
Macro name : cisco-desktop
Macro type : customizable
# Basic interface - Enable data VLAN only
# Recommended value for access vlan (AVID) should not be 1
switchport access vlan $AVID [access_vlan_id]
switchport mode access
# Enable port security limiting port to a single
# MAC address -- that of desktop
switchport port-security
# Ensure port-security age is greater than one minute
# and use inactivity timer
# "Port-security maximum 1" is the default and will not
# Show up in the config
switchport port-security violation restrict
switchport port-security aging time 2
switchport port-security aging type inactivity
# Configure port as an edge network port
spanning-tree portfast
spanning-tree bpduguard enable
Switch# show parser macro description
Interface
--------------------------------------------------------------
Fa2/9
--------------------------------------------------------------
cisco-phone
This example shows how to use the system-defined macro cisco-phone to assign a value of 35 to the
access VLAN and 56 to the voice VLAN on the Fast Ethernet interface 2/9.
Note This macro requires the $AVID and $VVID keywords, which are the access and voice VLANs of the
port.
Switch(config)# interface fastethernet2/9
Switch(config-if)# macro apply cisco-phone
Switch(config-if)# macro description cisco-phone $AVID 35 $VVID 56
Switch(config-if)# end
Switch# show parser macro name cisco-phone
Macro name : cisco-phone
OL-25340-01
Macro Description
cisco-desktop
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
Configuring SmartPort Macros
18-11