Onboard Headers And Connectors - ASROCK N68-GS4 FX R2.0 User Manual

2.6 Onboard Headers and Connectors

2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•
Serial ATA2 Connectors
(SATAII_1 (PORT 0.0):
SATAII_2
see p.10 or 11, No. 6) (PORT 0.1)
(SATAII_2 (PORT 0.1):
see p.10 or 11, No. 5)
SATAII_4
(PORT 1.1)
(SATAII_3 (PORT 1.0):
see p.10 or 11, No. 7)
(SATAII_4 (PORT 1.1):
see p.10 or 11, No. 8)
USB 2.0 Headers
(9-pin USB5_6)
(see p.10 or 11 No. 13)
(9-pin USB7_8)
(see p.10 or 11 No. 12)
USB 3.0 Header
(for N68-GS4/USB3 FX R2.0 only)
(19-pin USB3_1_2)
(see p.10 No. 18)
IntA_P_SSRX+
IntA_P_SSRX-
Vbus
IntA_P_SSRX-
Print Port Header
(25-pin LPT1)
SLCT
PE
BUSY
(see p.10 or 11 No. 14)
These four Serial ATA2 (SATA2)
connectors support SATA2
SATAII_1
(PORT 0.0) or SATA hard disk for internal
storage devices. The current
SATA2 interface allows up to
SATAII_3
(PORT 1.0)
3.0 Gb/s data transfer rate.
There are two USB 2.0 headers
USB_PWR
P-
on this motherboard. Each
P+
GND
DUMMY
USB 2.0 header can support two
USB 2.0 ports.
1
GND
P+
P-
USB_PWR
There is one USB 3.0 header on
ID
IntA_P_D+
this motherboard. This USB 3.0
IntA_P_D-
GND
header can support two USB
IntA_P_SSTX+
IntA_P_SSTX-
3.0 ports.
GND
1
Vbus
IntA_P_SSRX+
GND
IntA_P_SSTX-
IntA_P_SSTX+
GND
IntA_P_D-
IntA_P_D+
This is an interface for print
STB#
SPD0
SPD1
port cable that allows
SPD2
SPD3
SPD4
convenient connection of printer
SPD5
ACK# SPD6
SPD7
1
devices.
SLIN#
GND
PINIT#
ERROR#
AFD#
1 9 1 9 1 9 1 9 1 9