Panasonic TX32LX80 Operating Instructions Manual page 21

Note]
You can control the theatre speaker with this TV remote control (point.the remote
control at the TVs signal receiver).
OThis function is available with Amplifier or Player theatre which has UHDAVI
Control" function.
*If you cannot operate, check the 'VIERA Link" setting in 'Setup menu" (page 18)
and the equipment,
VIN
0 Display "VIERA Link menu"
0 Select "Speaker Selection"
431P
N
77A I-
+
OW
Set to "Home Cinema" or"W"
142_-O select
0
H ome Cinema
Amplifier or Player theatre will be automatically turned on if it is in Standby
mode and sound will be output from the theatre speakers connected to the
equipment.
0 Volume up / down *
0 Mute*
I
" The sound of TV speakers is mute.
" When the equipment is turned off, TV speakers will be active.
N TV
TV speakers are active.
" This function may not work properly depending on the connected equipment.
" Image or sound may not be available for the first few seconds when playback starts or input mode is
switched.
" Volume function will be displayed when adjusting the volume of the equipment.
" Easy playback is also available when using the remote control for Amplifier or Player theatre. Read the
manual of the equipment.
" About HDMI cable for connecting Panasonic HD Video Camera, read the manual of the equipment.
" If more than one equipment of the same type are connected to the TV by HDMI cables, for example two
DIGA Recorders to HDMI1 and HDMIZ VIERA Link will only be available for the lower terminal number,
in this case HDMI1.
" "HDAVI Control 3" is the latest standard (current as of December, 2007) for HDAVI Control compatible
equipment. This standard is compatible with conventional HDAVI equipment.
21