Troubleshooting Procedures By Error Modes - Samsung SP42L6HN Service Manual

6-2 Troubleshooting Procedures by Error Modes

6-2-1 Installation & Connection
● : Light is On
◑ : Light is Blinking
○ : Light is Off
TIMER LAMP STAND BY/TEMP
○ ○ ●
○ ◑ ○
● ◑ ○
◑ ○ ◑
○ ◑ ◑
○ ○ ◑
◑ ◑ ◑
＊ It takes about 30 seconds for the TV to warm up, so normal brightness may not appear immediately.
＊ The TV has a fan to keep the inside lamp from overheating. You'll occasionally hear it working.
Samsung Electronics
Standby state.
The picture will automatically appear in about 15 seconds.
Auto Timer ON/OFF has been set and the set will automatically be turned on in about 25
seconds.
A cooling fan inside the set is not operating normally.
Lamp cover on rear of the set is not properly shut.
Check if the ventilation hole on the rear of the set is blocked, because if the inner
temperature is too high, the power will shut off.
Lamp may be defective.
POWER
Press to turn the TV on and off.
Remote Control Sensor
Aim the remote control towards this spot on the TV.
Indication
Troubleshooting
6-7