PC mode
Setup
During PC mode
Press the MENU button.
Move to choose Setup menu.
Access Setup menu.
Move to choose menu option.
Adjust chosen option or access chosen menu.
Press the EXIT button at any time to exit Setup menu.
PC setup
Access to adjust chosen option.
Input resolution : Displayed during VGA, WVGA, XGA, WXGA input signals.
Select WVGA or WXGA during WVGA or WXGA input signal to avoid noise.
Select VGA or XGA during VGA or XGA input signal to avoid noise.
Note:
WVGA and WXGA signals may not be displayed properly.
Clock
: If a periodic striped pattern (noise) occurs, carry out adjustments to reduce the noise to the
lowest level.
H-pos
: Adjust the horizontal position.
V-pos
: Adjust the vertical position.
Clock phase : Eliminate the flickering and distortion.
Carry out this adjustment after adjusting Clock.
Adjust to reduce noise to the most inconspicuous level.
Sync
: H & V - To synchronize by the horizontal and vertical signals from your PC.
On G - To synchronize by the green signal from your PC (if available).
H-freq. / V-freq.
Displays the frequency of PC input signal.
If the input signal is not applicable, the characters will turn to red.
For applicable PC signals information see page 37.
Note:
H-FREQ. / V-FREQ. is displayed on the upper right of the screen during PC setup.
Main menu
MENU
Picture menu
Sound menu
Setup menu
OK
PC setup
Input resolution
Clock
H-pos
V-pos
Clock phase
Sync
EXIT
VGA
H & V
23