Connections - Panasonic TH-42PWD6 Operating Instructions Manual

Connections

When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
(Example: TH-42PWD6)
Speakers (Optional accessories)
SPEAKERS
Terminals (R)
– Cable fixing bands Secure any excess cables with bands as required.
Pass the attached cable
fixing band through the
clip as shown in the
figure.
1
Optional Terminal Board insert Slots (covered)
SLOT1
AC cord connection
(see page 12)
– AC cord fixing
1. Open the clamper.
Clamper
Note: The power plug in the illustration may not be the type fitted to your set.
To secure cables connected to Terminals, wrap the cable fixing band around
them then pass the pointed end through the locking block, as shown in the
figure.
While ensuring there is sufficient slack in cables to minimize stress
(especially in the power cord), firmly bind all cables with the supplied
fixing band.
2
SLOT2
SPEAKERS
Terminals (L)
2. Insert the AC cord and
close the clamper
securely.
AC cord
To tighten:
Pull
SLOT3
From EXTERNAL monitor terminal
on Computer (see page 8)
1
2
2
3. Slide up the clamper and fix
the AC cord plug securely.
When loosen
the clamper:
To loosen:
Push the catch
AUDIO
PC IN SERIAL
From SERIAL terminal
on Computer
1
Pull
7