Accessories; Accessories Supply; Remote Control Batteries - Panasonic TH-42PWD6 Operating Instructions Manual

Accessories

Accessories Supply

Check that you have the accessories and items shown
Operating Instruction book
AC cord

Remote Control Batteries

Requires two R6 batteries.
1. Turn the transmitter face down.
Press and slide off the battery
cover.
Helpful Hint:
For frequent remote control users, replace old batteries with
Alkaline batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon" with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display
set.
6
Remote Control
Transmitter
EUR646529
INPUT
SURROUND
VOL
N R
PICTURE SOUND SET UP
MULTI
PIP SWAP SELECT MOVE
PICTURE
POS. /SIZE ASPECT
PC OFF TIMER
PLASMA DISPLAY
Fixing bands
2. Install the batteries as shown in
the battery compartment.
(Polarity + or – must match the
markings in the compartment.)
Batteries for the Remote
Control Transmitter
(2 R6 Size)
Ferrite core
(small size) 1
3. Replace the cover and slide in
reverse until the lock snaps.
Two "R6" size
Ferrite core
(large size) 2