Power Failure Recovery - Electrolux EWT8541 User Manual

This can be corrected by adjusting
the washing machine legs as
described in the Installation
Instructions sheet supplied with
your machine.
- If "Eco" rinse option selected,
this function will not operate.
-
This function will not operate in
"Tub Cleaning" and Drain + Spin"
programs.
-
If "Extra" rinse option is selected,
self clearing steps will be repeated
up to 6 times.

Power Failure Recovery

When there is power failure while
machine is washing or rinsing or
spinning. The machine tries to save
the settings at which stage the
machine is doing and then when the
power returns back the machine will
starts washing from the stage
where it is left off.
Button Response and Lights
Always press buttons gently. Watch
the lights on the control panel to
see the effect pressing a button or
turning a program selector knob
has, and listen for "BEEPS".
When you press a button you will get
a short "BEEP" to acknowledge the
entry. If the option is not available at
the time, the machine will not allow
you to select it, and you will here the
three short "BEEP" to remind you the
option is not available and the
display will show "
After the machine has started, the
entire wash option button will be
disabled and the display will show
" " and flashing with three short
beeps to indicate the button is
disabled (except Start/Pause button).
" and flashing.
All functions of the washing
machine will stop when the
lid is open.
Enabling/Disabling End-of-
Wash Beeping Mode
This mode permits you to either
enable or disable the beeping (3
beeps every 20 seconds) at the end
of the wash. As an example, you
might wish to disable this beeping
when you start a wash when going to
bed, so that when the wash finished,
it will not disturb you through the
night.
To change the "beeping" selection,
proceed as follows:
If you want to DISABLE the
"beeping" sound, when the
washing machine in
Stand-By-Mode (after 7 seconds
passed from machine switching
on), press "Soak Time" and
"Water Level" buttons at the
same time until you hear 2 shorts
"BEEP" sound.
To return to default configuration
press these 2 buttons at the
same time until you hear "BEEP"
sound.
NOTE:
All error beeping is not disabled
by this feature, such as a critical
fault, or lid open during
fill/agitate/spin, or out of balance
during spinning.
Responding sound while pressing
the button is not disabled by this
feature.
ENGLISH 7