Trouble Shooting - Electrolux EWT8541 User Manual

9.

TROUBLE SHOOTING

DO NOT call for service until you have checked the points listed below.
If you call for service and there is nothing wrong with your washing machine, you will
have to pay for the service call.
You will have to pay even when your washing machine is under warranty. Before you
call for service, check the points in the table below.
If after all checks, the problem persists, contact your local Service Centre.
Problem
Machine not
working.
Machine has
washed load
but will not
spin.
Water in wash
bowl.
Will not fill
with water.
Machine goes
out of balance
or vibrates
excessively
when spinning.
Water on floor.
Display Possible Causes
Code
Power not switched on.
No electricity supply through
the power point.
Water taps not turned on.
Out of balance switch off.
EF0
Lid not fully closed.
The main supply is unstable.
EH0
Out of balance.
EF0
Lid not fully closed.
Drain hose blocked.
Water taps not turned on.
Inlet hoses blocked.
Machine not level.
Levelling feet not adjusted.
EF0
Clothes not evenly distributed.
Loose inlet hose connections.
Loose drain hose connections.
ENGLISH
What to do
Switch on power point.
Check power point with
another appliance.
Turn on taps.
Open lid, redistribute load and
close lid.
Close lid and press Start/Pause
to resume operation.
Wait until the main supply is
stable and the appliance
automatically starts operating.
Open lid, redistribute load,
close lid.
Close lid and press Start/Pause
to resume operation.
Check drain hose for blockage.
Wait a short while, the wash
will continue.
Turn taps on.
Clean tap filters/washers.
Make the machine level.
Adjust feet to touch the floor.
Redistribute clothes evenly.
Check connections at taps and
rear of machine.
Check connections at rear of
machine.
25