Epson Stylus Photo RX585 Service Manual page 82

EPSON Stylus Photo RX585/RX595/RX610
When installing the CD-R Shaft, orient it so that the side where the
distance from the shaft end to the hole for the hook of the gear is
larger is positioned left (on the spring side), and pass it through the
Stacker. (Fig. 4-53)
Before tightening the screws, confirm the following conditions:
♦Right and Left Stacker Guides have been installed properly.
(Check the 2 locating holes and 1 protrusion)
♦Stacker has been installed properly. (Check the following
positions with the Stacker in the down position.) (Fig. 4-54)
• Protrusions (x2) in the rear (under the Stacker Guides)
• Protrusions at right and left sides (inserted in guide groove)
Tighten the screws in the specified order.
See Fig. 4-55 for installation of the CD-R Guide Lever Spring.
C H E C K If the Stacker is not horizontal in the right and left direction,
P O I N T
remove the right gear, and install the gear again with the Stacker
in the highest position.
Longer side positioned left
Hook hole
Figure 4-53. Installing the CD-R Shaft
Disassembly and Assembly
(Fig. 4-51)
Install the gear with the shaft
in the highest position
CD-R Shaft
Hook hole
Disassembly of Housing Lower Assy
Insert the protrusion under the guide
Insert the protrusion
into the guide groove
Figure 4-54. Installing the Stacker
2.Insert the hook end into the guide
1.Put the ring on the shaft
After installing the spring, move Stacker up and down and check the installation of the spring.
~Down~
Figure 4-55. Installing the CD-R Guide Lever Spring
Revision B
Stacker is in the down position
3.Push the ring onto the gear
~Up~
82