Epson Stylus Photo RX585 Service Manual page 28

EPSON Stylus Photo RX585/RX595/RX610
1.7.4.4 Operating Specifications during Connecting DSC
Table 1-31. Operations during Connecting DSC
Operation
Connecting When a DSC is connected as described in
DSC Procedure (p.27)" Step 3-(1), USB Direct Print or PictBridge logo is
(print start) displayed on the LCD.
A print job can be canceled from the DSC.
Canceling
printing
The [Stop/Clear setting] button on the control panel also cancels the print job.
When performing memory card direct print after printing from a DSC, the
After printing
USB cable connecting the DSC must be disconnected from the printer in
is completed
advance.
Print settings made on both the DSC and the printer can become impossible
settings for the printer due to unsupported combination of paper type, paper
size and layout. In such case, the print settings are automatically changed as
follows.
USB Direct Print
The selected paper type is maintained, and the paper size and layout
Exclusion
settings are changed to the default for the selected paper type.
control
PictBridge
The settings made on the DSC are maintained. Any print setting items that
are not specified by the DSC are changed in accordance with the DSC
settings. When the paper type is changed, changed to Prem. Glossy, when
the paper size is changed, changed to 4x6 size. And when the layout is
changed, changed to Borderless layout.
Product Description
Specifications
"1.7.4.3 General Operation
Specifications of Each Function
1.7.4.5 EXT.I/F (USB Host) Specifications for Connecting DSC
Table 1-32. Operations when USB Cable is Connected/Disconnected
Printer status Connecting
When the printer detects a DSC
connected, it goes into the camera
Standby direct mode. If the printer failed to
recognize the DSC normally, the
printer displays a camera direct error.
The printer does not go into the
An error is camera direct mode except when the
occurring error is memory card-related error,
Index Sheet error, or Ink low error.
Panel power Same as when the printer is in
save mode standby mode.
Table 1-33. Handling Print Job Requirement from PC when Connecting DSC
EXT.IF (USB Host) DSC Connecting Status
Requirement
from PC
Normally Connected
Print job Returns "Busy" to the PC.
Scan job Returns "Busy" to the PC.
Read memory
Allows the access.
card
Write Not allows the access. Notifies the
memory card PC that the operation is not available.
Maintenance Returns "Busy" to the PC.
Revision B
Disconnecting
When the DSC is disconnected after
it is normally recognized by the
printer, the printer returns to the
standby mode.
When a camera direct error has
occurred, the printer recovers from
the error and returns to the previous
state (the state before the camera is
connected). If the error occurs for the
camera connected before the printer
is turned on, the printer returns to the
initial state after the power-on.
The printer does not recover from the
power save mode. When any button
except the Power button is pressed,
the printer returns to the camera
direct mode. If the printer detect no
camera at this time, it returns to the
previous state (the state before the
camera is connected)
Camera Direct Error is Occurring
Cancels the error state and performs
the job.
Cancels the error state and performs
the job.
Allows the access.
Allows the access.
Cancels the error and carries out the
required task.
28