Epson Stylus Photo RX585 Service Manual page 48

EPSON Stylus Photo RX585/RX595/RX610
Category Error Code
Factory
command 30H Error by EEPROM verify command
error
40H Transistor ambient temperature abnormal
41H Error in X-Hot detection before printing
Head system
error
42H Error in X-Hot detection after flushing
43H Head ambient temperature abnormal
50H Home seek error
51H CR unlocking error
Sequence 52H CR locking error
error
Paper detect error before initial charge
53H
completion
56H Overhit error at ink replacement
60H PW detection error (Hi check error)
61H PW detection error (Low check error)
Sensor error
62H Tray detection (CDR detector 2) error
63H Paper detection error
Troubleshooting
Table 3-3. Fatal Errors (continued)
Error Cause
The thermistor on the
printhead detected abnormal
temperature.
An error occurred in the
carriage operating sequence.
PW detector trouble
Sensor trouble
Troubleshooting When There is Error Display
Checking the following parts and replace the defective one:
♦Main Board
(p.66)
♦Power Supply Board
(p.80)
Checking the following parts and replace the defective one:
♦Printhead
(p.73)
♦Main Board
(p.66)
♦Power Supply Board
(p.80)
♦Replace the Head FFC
See Remedy for DC error (CR motor)
Checking the PW Sensor (p.90)
♦Checking the PW Sensor for adhesion of dirt and dust
♦Checking the connection of the FFC
Making the following adjustments:
♦PW adjustment
Checking the following parts and replace the defective one:
♦Head FFC
♦Carriage Assy
(p.89)
♦Main Board
(p.66)
♦Power Supply Board
(p.80)
Checking the operation of the actuator and the connection of the connector.
Checking the following parts and replace the defective one:
♦Sensor
♦Main Board
(p.66)
♦Power Supply Board
(p.80)
Revision B
Remedy
48