Figure 16. Correct Jumper Use
info@Fluke-Direct.ca
8.
If necessary, change between °C, °F, K, and °R
temperature units in Setup:
1.
Push s.
2.
Push the Next Page softkey twice.
3.
Push and to move the cursor to
Temperature Units.
4.
Push or the Choices softkey to choose a
setting for that parameter.
5.
Push or to move the cursor to the necessary
setting.
6.
Push to go back to the s display.
7.
Push the Done softkey or s to exit Setup mode.
9.
If necessary, change between ITS-90 or IPTS-68
Temperature Scale in Setup mode. The procedure is
the same as steps 1-7 above.
gks14f.eps
Fluke-Direct
.ca
Documenting Process Calibrator
Measure Mode
1.800.868.7495
41