Connections - Panasonic H-37PWD7UY Operating Instructions Manual

Connections

When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
(Example : TH-42PWD7UY)
Speakers (Optional accessories)
AC cord connection (see page 13)
S P E A K E R S
Terminals (R)
– AC cord fixing
1. Open the clamper.
– Cable fixing bands
Secure any excess cables with bands as required.
Pass the attached
cable fixing band
through the clip as
shown in the figure.
1
SLOT1
Optional Terminal
Board Insert Slot
(covered)
Note: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3. TH-37PWD7UY has 2 SLOTs only.
Clamper
Note: The power plug in the illustration may not be the type fitted to your set.
To secure cables connected to Terminals, wrap the cable fixing band
around them then pass the pointed end through the locking block, as
shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress
(especially in the power cord), firmly bind all cables with the
supplied fixing band.
2
R AUDIO L VIDEO OUT
VIDEO IN
IN
AV
S VIDEO IN
SLOT2
COMPONENT/RGB IN
AV Terminals
and Audio IN Terminals
(see page12)
(see page12)
S P E A K E R S
Terminals (L)
2. Insert the AC cord and
c l o s e t h e c l a m p e r
securely.
AC cord
To tighten:
Pull
R AUDIO L P /C /R P /C /B Y/G
R R B B
COMPONENT/RGB IN
SLOT3
From EXTERNAL
monitor terminal on
Computer (see page 10)
1
2
2
3. Slide up the clamper and fix
the AC cord plug securely.
When loosen
the clamper:
To loosen:
Push the
catch
Pull
AUDIO
PC IN SERIAL
From SERIAL
Terminal on Computer
(see page 11)
1
9