Pan Screen - Yamaha MonitorMix User Manual

PAN screen

Configures the pan/balance for each input channel on one's own
monitor bus.
The PAN screen will not appear for a monaural bus.
PAN control bar
1
Drag the bar range up and down to adjust the pan for each channel.
You can also double-tap this area to set the pan or balance to the
center position.
The orange bar shows the pan position. The green line shows the
center position.
Stereo channel operation will vary when switching between PAN mode
and BALANCE mode on the mixer.
When in PAN mode, you can adjust the pan for the left and right
channels independently of one another.
When in BALANCE mode, the pan position of the left and right
channels are always linked.
NOTE
• If Pan Link is enabled on your monitor bus, you will be able to see the PAN screen
but will not be able to adjust the pan. For the TF series, you can adjust the pan for
the STIN/FXRTN channel even if Pan Link is enabled.
• The PAN control bar will not appear if your monitor bus is stereo and the BUS TYPE
is FIXED.
Bus balance bar
2
Adjusts left and right balance levels for the entire monitor bus.
The orange bar shows the balance position. The green line shows the
center position.
MonitorMix User Guide
1
PAN mode BALANCE mode
2
15