Kodak 750 Manual page 9

trademark (or emulsion) side of slide No. 2 should face
toward slide No. 1; No.3 should face toward No.2, etc.
Replace the lock ring, turning it in the direction of the
arrow marked LOCK until the ring is secure on the tray.
NOTE: If you wish to darken the screen after the showing
of 80 slides, see the instructions on page 13 under "Editing
Slides."
~
PLACING SLIDE TRAY ON PROJECTOR
Put the loaded slide tray on the projector so that the hole in
the center of the tray fits over the center post on the top of
the projector; then revolve the tray slowly until the identifi-
cation number "0" is opposite the GATE INDEX on the
projector. The tray will drop down into operating position
on the top of the projector. If the slide tray does not drop
easily into place, refer to "Loading Slide Tray" on page 8.
9