Table 2-1 Condensed Specifications - Honeywell UDC2300 Product Manual

Installation
Pre-installation Information
If the controller has not been removed from its shipping carton, inspect the carton for
damage then remove the controller.
• Inspect the unit for any obvious shipping damage and report any damage due to transit
to the carrier.
• Make sure a bag containing mounting hardware is included in the carton with the
controller.
• Check that the model number shown on the inside of the case agrees with what you
have ordered.
Condensed Specifications
We recommends that you review and adhere to the operating limits listed in Table 2-1
when you install your controller.
Operating Limits
Accuracy
CE Conformity Special
Conditions (Europe)
4

Table 2-1 Condensed Specifications

Ambient Temperature: 32 °F to 131 °F (0 °C to 55 °C)
Relative Humidity: 5 % to 90 % RH up to 104 °F (40 °C)
Vibration:
Frequency: 0 Hz to 200 Hz
Acceleration: 0.6g
Mechanical Shock:
Acceleration: 5 g
Duration: 30 ms
Power:
90 Vac to 264 Vac, 50/60 Hz
(CSA models rated to 250 Vac maximum)
Power Consumption: 12 VA maximum
± 0.25 % of span typical
± 1 digit for display
15-bit resolution typical
Shielded twisted-pair cables are required for all analog I/O,
process variable, RTD, thermocouple, dc Millivolts, low level
signal, 4-20 mA, digital I/O, and computer interface circuits.
Refer to 51-52-05-01, How to Apply Digital Instrumentation in
Severe Electrical Noise Environments, for additional
information.
UDC2300 Limit Controller Product Manual 1/01