Attaching The Labels, Setting Paper, Checking Images/Operations, And User Mode - Canon ImageRunner iR8500 Series Service Manual

- Shut-Down Warning Label
1)Select the Shut-Down Warning label [1] of the appropriate language;
then, attach it to the left of the main power switch of the machine's
right cover (rear).
2.2.39 Attaching the Labels, Setting Paper,
Checking Images/Operations, and User Mode
iR105i/iR105+ / iR9070
1) Check to make sure that the front deck and the cassette are free of any
packing material.
2) Connect the power plug to the power outlet, and turn on the main
power switch.
- Adjust the contrast of the control panel display using the Image
Contrast dial for the best view, and advise the user on the use of the
dial.
- Check to see that the Add Paper message goes ON.
- Press the keys on the keypad and the Clear key to see that the copy
count is correctly indicated.
3) Check with the user to decide on a paper size.
4) Press the release button, and slide out the right/left deck.
To change the size of the front deck (right/left), refer to 2.14.
5) Attach the 3-Hole Paper Set labels [1].
6) Put paper in the right/left deck.
7) Push in the right/left deck. Peel off the appropriate deck size label [1]
from the size label liner (cassette/deck), and attach it on the paper
size plate of the deck.
[1]
F-2-181
0007-6730
[1]
F-2-182
[1]
8) Press the release button, and slide out the cassette 3/4.
9) Attach the 3-Hole Paper Set labels [1].
[1]
10) Peel off the appropriate cassette size label [1] from the liner of the
size label (cassette/deck), and attach it on the paper size plate [2] of
the cassette. Put the paper size plate in place on the cassette cover.
[1]
11) Push in the cassettes into the copier.
12) Start service mode.
MEMO
Starting Service mode
- Press the Additional Function key.
- Press the '2' and '8' keys at the same time on the keypad.
- Press the Additional Function key.
Never turn off the power while the machine is in operation.
13) Make the
COPIER>FUNCTION>INSTALL>TONERS.
14) See that the following message has appeared: 'Check the Developer'.
15) Check to see that the developing assembly and the developing
assembly locking plate are correctly mounted; then, press the OK
key.
16) The machine starts to supply toner. (about 10 min; progress shown
on display by count-down)
17) At the end, make the following selections to generate 2 A3 solid
Chapter 2
F-2-183
F-2-184
[2]
F-2-185
following selections:
2-43