Checking The Developing Assembly; Mounting The Charging Assembly - Canon ImageRunner iR8500 Series Service Manual

[3]
5) Remove the tape used to keep the tag in place, and open the top [1] of
the fixing/ feeding assembly; then, remove the 2 fixing nip releasing
screws [2] at the front and rear.
[1]
Close the top of the fixing/feeding unit.

2.2.13 Checking the Developing Assembly

iR105i/iR105+ / iR9070
1) Open the manual feed tray unit.
2) Take out the developing assembly from the package that comes with
the machine.
Turn the developing cylinder by hand to check it for scratches.
3) Holding the developing assembly [1] as shown, mount it to the
machine.
When mounting the developing assembly, fit it from a high position, and
take care not to bring the developing cylinder into contact with the plate
of the developing assembly base.
4) Connect the 2 connectors [1].
[2]
[1]
F-2-94
[2]
F-2-95
0007-6638
[1]
F-2-96
5) Secure the developing assembly locking unit [1] with the 6 TP screws
[2] (M4x6; black) that come with the machine.
[2]
Be sure that the developing assembly locking unit is firmly in contact
and is free of displacement to avoid image faults. (Particularly, it must
not ride overt the boss found at the bottom.)
6) Fit the door tape of the manual feed tray cover with a screw (M4x8;
w/ washer: black).
(Keep the manual feed tray cover open).
[2]

2.2.14 Mounting the Charging Assembly

/ iR85+
1) Remove the screw [2], and detach the transfer/separation assembly
front cover [1].
Chapter 2
[1]
F-2-97
[1]
[2]
[2]
F-2-98
[3]
[1]
F-2-99
0007-2902
2-27