Receiving Documents; Reception Modes - Panasonic PANAFAX UF-333 User Manual

Receiving Documents

04004000002

Reception Modes

You can select one of the four modes as shown below.
04004010003
04004040003
Conditions
Y You normally receive ll
only voice calls.
You receive both voice
and fax calls.
You normally receive You normally receive
fax calls only.
You receive both voice
and fax calls. And a d f ll
Telephone Answering
Machine (TAM) is
04004080002
connected.
Note:
04004070001
04004070002
60
Suggested Reception Mode
i
You can answer the incoming call via an External
Telephone (Optional). If you receive a fax calling
signal, simply press START to receive manually.
(see page 61)
Fax / Tel Auto Switching Mode
Unit will answer the incoming call then
distinguishes whether it is voice or fax call. If it is
a fax call, the unit will receive automatically. if it is
a voice call, the unit will signal (rings) through the
speaker for your attention. (see page 62)
Unit will receive the document automatically. All
incoming calls (including a voice call) are
answered by the fax machine. (see page 63)
A d
The TAM answers the incoming call. During that
time, the unit also monitors whether it is a voice
call, the TAM continues to operate. If it is a fax
call, the unit will automatically switch the line to
fax and begin receiving document. (see page 64)
1. Depending on the model of the Telephone Answering Machine (TAM) that is connected, some of the
features may not be compatible with your fax machine operating in the TAM Interface mode.
2. If you are using the "Distinctive Ring Service" provided by your local telephone company, please note
that the ring pattern for your fax number must match with the setting of Fax Parameter No. 36 (RING
PATTERN DETECT). (see page 37)
If the setting does not match with the ring pattern, your machine will not receive a document
automatically and the telephone will continue to ring.
Furthermore, if your TAM does not support the "Distinctive Ring Detector" service, it may not function
properly in TAM Interface.
Telephone Mode
(IN Mode)
(IN Mode)
Fax Mode
(OUT Mode)
TAM Interface Mode
(OUT Mode)
Settings
Fax Parameter No. 15 set
to 1 : Tel
OUT
Lamp : OFF
Fax Parameter No. 15 set
to 2 : Fax / Tel SW.
OUT
Lamp : OFF
Fax Parameter No. 16 set
to 1 : Fax
OUT
Lamp : ON
Fax Parameter No. 16 set
to 2 : TAM I/F.
OUT
Lamp : ON