Printer Configuration - CognitiveTPG A799II Programming Manual

Printer configuration

Printers are shipped with all the functions and parameters preset at the factory. Settings for various printer parameters
can be changed. This menu is printed on the receipt and scrolls through instructions for selecting and changing any of the
functions or parameters.
Caution: Be extremely careful changing any of the printer settings to avoid inadvertently changing other settings that
might affect the performance of the printer.
The following functions and parameters can be changed in the scrolling configuration menu (except as noted):
• Communication Interfaces
Baud rate
Parity
Hardware (DTR/DSR) or software (XON/XOFF)
flow control
Data reception errors
Alternate DTR/DSR
USB Driver
USB NAK
Bluetooth Discoverable
Bluetooth Class
• Diagnostics Modes
Normal
Datascope (with or without graphics)
Receipt test
• Printer Emulations
Native mode
A794 emulation
A793 emulation
LEGACY emulation
Chapter 2: Diagnostics and Configuration
• Emulation/Software options
Printer ID mode
Default lines per inch
Carriage return usage
Code 128 Check Digit
Default font
Font size
Journal Print
• Hardware options
Color density
Monochrome print density
Max Power
Partial cut distance
Fine partial cut steps
Paper low sensor
Paper low threshold extension
Printhead setting (cannot change)
• Paper type
• Firmware features
Paper selection lockout
Beep after knife cut
Cash drawer open after knife cut
Energy Savings Timeout Value
Print quality level
For more information about See this section
Using the configuration menu "Configuring the printer"
to configure the printer
A799-2PG0001B 4/2016
15
on page 16.