Table of Contents
Advertisement
Remote Operation (KX-FP155 only)
Other remote operations
Erasing a specific message
Press *4 while listening to the message you
want to erase.
Voice guide example:
The message has been erased.
A long beep will sound. The unit will then play
back the next message.
Erasing all the messages
Press *5 to erase all the messages.
All messages have been erased.
A long beep will sound.
Monitoring the room (Australian users only)
Press 6 to monitor the sound for about 30
seconds in the room where the unit is installed.
After 30 seconds, a beep sounds. To continue
monitoring, press 6 again within 10 seconds.
Recording a marker message
You can leave an additional message.
1. Wait for the voice guide.
All messages have been played
2. Wait about 10 seconds.
Please leave your name and
message after the beep.
3. Leave a message after the beep.
Re-recording a greeting message
You can change the contents of the greeting
messages for TAD/FAX mode.
1. Press 7 to start recording.
A long beep will sound.
2. Speak clearly up to 16 seconds.
If you pause for over 2 seconds, 6 beeps
will sound and the recording will stop.
Repeat from step 1 within 10 seconds.
3. When finished recording, press 9.
The new greeting message will be played.
Skipping the greeting message
Press 0 during the greeting message playback.
The unit will skip the rest of the greeting
message.
Turning the message transfer on or off
You must pre-program a transfer telephone
number beforehand (feature #60 on page 69).
Press 81 to turn ON the message transfer.
Message transfer is set.
Transfer phone number is 123···.
Press 82 to turn OFF the message transfer.
Message transfer is off.
If a transfer telephone number is not
programmed, you cannot turn this feature ON.
Transfer phone number is not set.
Turning the pager call on or off
You must program a pager number beforehand
(feature #70 on page 70).
Press 83 to turn ON the pager call.
Pager call is set.
Pager number is 098765432.
Press 84 to turn OFF the pager call.
Pager call is off.
If a pager number is not programmed, you
cannot turn this feature ON.
Pager number is not set.
.
Changing the receive mode
Press 80 to change the receive mode from
TAD/FAX to TEL.
You cannot return to TAD/FAX mode in the same
call. To return to TAD/FAX mode, see below.
Returning to the TAD/FAX mode
1. Call your unit and wait for 10 rings.
You will hear a beep signal.
2. Enter the remote operation ID (feature #11 on
page 63) within 8 seconds.
You will hear a beep signal.
3. — To return to the TAD/FAX mode:
Wait for 3 seconds, then the greeting
message will be played.
— To return to the TEL/FAX mode:
Press # within 3 seconds.
— To return to the TEL/FAX mode:
Press * within 3 seconds.
Note:
Enter the remote operation ID within 8 seconds
after hearing the beep, otherwise the call will be
interrupted and the unit will remain in the TEL mode.
55
Advertisement
Table of Contents
