Table Of Contents - Onkyo HT-RC630 Service Manual

DEBUG MODE-1
AUDIO DEBUG MODE-1/5
The operations of DSP and DIR etc are able to checked by the information displayed on FL in this debug mode.
This information will help to analysing digital audio no sound trouble.
To set in Debug mode
1. Press twice the ON/ STANDBY key while pressing the DISPLAY key.
e.g.
2. Press + (TONE) button while the version number of microprocessor is displayed.
e.g.
3. Press DISPLAY button while the version number of DSP is displayed.
e.g.
4. Proceed to the next step by pressing the DISPLAY key.
M 1 .0 3 /1 4 3 0 7 AL N
N 1 .0 2 /1 4 2 1 0 A L A
0 A0 0 0 2 : :0 0
AN A:o :N ON : C :
1 :AN A _ 0 4 8 k 0 4 8 k
2 /0 .0 :_ 2 .0 :3 /4
2 :o :PCM _:PC M _ _
_ 0 0 :x:F:O FF_ _ _
SP0 0 F _0 0 F 0 0 4 0 9
_ 4 8 _ 4 8 2 5 6 STB _ _
L :0 0 0 0 0 0 0 0
SW :0 0 0 0 0 0 0 0
TX-SR333/ HT-R393/ HT-RC630
The version number of Microprocessor is displayed
only for 3 seconds.
The version number of DSP is displayed
only for 3 seconds.
Step-1
Step-2
Step-3
AUDIO dubug mode
Step-4
The status of DSP and DIR etc
will be displayed.
Step-5
Step-6
Step-7
Step-8
Exit