Speakers Set - Yamaha RX-V359 Service Manual

RX-V359/HTR-5930

4. SPEAKERS SET

The input signal is automatically identified and switched in
the priority order of dts → DOLBY DIGITAL → PCM
AUDIO → Analog (A/D) according to the signal detection.
FRONT: SMALL 0dB
Presence Mix: 5ch
Tone Control +10dB
The analog switch settings for each sub-menu are as
shown in the table below.
1 FRONT: SMALL 0dB
2 CENTER: NONE
(Not applied to these models.)
3 LFE/BASS: FRONT
(Not applied to these models.)
4 Presence Mix: 5CH
(Not applied to these models.)
LARGE: This mode is used with a speaker having
high bass reproduction performance (a large
unit). Full bandwidth signals are output.
SMALL: This mode is used with a speaker having low
bass reproduction performance (a small
unit). The signals of 90Hz or less are mixed
into the channel specified by LFE/BASS.
NONE: This mode is used with no center speaker.
The center content is reduced by 3dB and
distributed to FRONT L/R.
Reference data
INPUT: DVD ANALOG (Both ch)
Sub-menu
1 FRONT: SMALL 0dB 1kHz Both ch, -20 dBm +6.0 dB +11.5 dBm
2 CENTER: NONE
(Not applied to these models.)
3 LFE/BASS: FRONT 50Hz Both ch, -20 dBm +6.0 dB
(Not applied to these models.)
4 Presence Mix: 5ch 1kHz Both ch, -20 dBm +6.0 dB +11.5 dBm
(Not applied to these models.)
5 Surround B Power 1kHz Both ch, -20 dBm +6.0 dB
(Not applied to these models.)
6 Tone Control Flat
7 Tone Control +10dB
8 Tone Control -10dB
24
CENTER: NONE
Surround B power
Not applied to these models.
Tone Control –10dB
Sub-menu CENTER SP SURROUND SP FRONT SP FRONT LEVEL LFE/BASS
LARGE
NONE
SMALL
Input level Volume
1kHz Both ch, -20 dBm +6.0 dB
1kHz Both ch, -20 dBm +6.0 dB +11.5 dBm +11.5 dBm +11.5 dBm
1kHz Both ch, -20 dBm +6.0 dB +13.4 dBm +11.5 dBm +11.5 dBm
1kHz Both ch, -20 dBm +6.0 dB
The signals output from the DSP block are the same as 1.
DSP THROUGH: YSS 0dB.
LARGE SMALL
LARGE LARGE
SMALL LARGE
– – –
FRONT: LFE of 5.1ch signal or LFE/BASS lower than
90Hz is distributed to FRONT L/R.
SWFR: LFE of 5.1ch signal or LFE/BASS lower than
90Hz is output through SUBWOOFER OUT.
Sub-menu
6 Tone Control Flat
7 Tone Control +10dB
8 Tone Control –10dB
SPEAKER OUTPUT (1kHz)
FRONT L/R CENTER SL/SR
- ∞
- ∞
+8.9 dBm
- ∞ - ∞
- ∞
- ∞ - ∞
+9.6 dBm +11.5 dBm +11.5 dBm
LFE/BASS: FRONT
Tone Control Flat
0dB SWFR
0dB SWFR
0dB FRONT
0dB –
Treble Bass
0 dB 0 dB
+10 dB +10 dB
–10 dB –10 dB
SUBWOOFER
OUTPUT (50Hz)
- ∞ - ∞
- ∞ - ∞
- ∞ - ∞
- ∞ - ∞
- ∞ - ∞
- ∞
- ∞
- ∞