Removing And Replacing The Vibrator Motor - Motorola C200 Service Manual

Level 1 and 2 Service Manual

Removing and Replacing the Vibrator Motor

6809464A58
1. Remove the battery cover, battery, SIM, endo assembly, and front endo assem-
bly as described in the procedures
2. Use the disassembly tool to carefully pry the vibrator motor from its location
in the rear endo assembly
away from the rear housing easily.
3. Separate the vibrator from the vibrator grommet.
Rear Endo Assembly
Vibrator Motor
Disassembly Tool
Figure 10. Removing the Vibrator Motor
4. To replace, insert the vibrator into the grommet. Ensure the vibrator shaft can
to rotate freely.
5. Align the vibrator assembly with the rear housing so the vibrator terminals
will contact the transceiver board contacts when reassembled, then press into
place until fully seated.
6. Replace the front endo assembly, endo assembly, antenna cover, SIM, battery,
and battery cover as described in the procedures.
May 21, 2003
.
.
as shown in Figure 10
Disassembly
The assembly should come
031328-o
23