Wireless - TP-Link TL-WR810N User Manual

Chapter 6
• Subnet Mask - An address code that determines the size of the network. Normally
255.255.255.0 is used as the subnet mask.
• Gateway - The gateway should be in the same subnet as your IP address.
• Allow remote access
address in browser.
Note:
• If you have changed the IP address, you must use the new IP address to login.
• If you select Smart IP(DHCP), the DHCP server of the router will not start up.
• If the new IP address you set is not in the same subnet as the old one, the IP Address pool in the DHCP Server will
be configured automatically, but the Virtual Server and DMZ Host will not take effect until they are re-configured.
6. 3.

Wireless

6. 3. 1. Wireless Settings
1. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2. Go to Wireless > Wireless
3. Configure the basic settings for the wireless network and click Save.
• Wireless Name of Root AP
• MAC Address of Root AP
• Mode - Select the desired mode. It is strongly recommended that you keep the
default setting 11bgn
the router.
Note:
If 11bg mixed mode is selected, the
be changed.
• Channel Width - Select any channel width from the drop-down list. The default setting
is Auto, which can automatically adjust the channel width for your clients.
• WDS Mode -This field determines which WDS Mode will be used. It is not necessary
to change the WDS mode unless you notice network communication problems
- Allow remote devices to access the router by inputting the IP
Settings.
- The SSID of AP that you want to connect to.
- The MAC address of AP that you want to connect to.
mixed, so that all 802.11b/g/n wireless devices can connect to
Channel Width field will turn grey and the value will become 20M, and cannot
Configure the Router in Repeater Mode
91