Assembly - Gravely Compact Pro 34 Operator's Manual

WARNING: AVOID INJURY. Read
and understand entire Safety
section before proceeding.
UNIT ASSEMBLY
Package Contents:
Unit, Mower Deck and Literature Pack
Preparation Checklist
Refer to the Owner/Operator manual as
required.
1. Unpack Unit - Remove shrink wrap and
packaging materials.
2. Remove Unit From Container - Open
Bypass Valves (dump valves) (See
Moving the Unit with the Engine Off on
page 16).
Push unit from container onto a level
surface. Close the dump valves.
3. Tires - See Specifications on page 30.
4. Seat - Connect the seat cable to the
frame with the hardware mounted on the
frame. Put the seat in the operating
position and secure with wing knob. See
Seat Adjustments on page 13 and
Service Position on page 18.
5. Position Steering Levers - Rotate
eccentric spacers to align handlebars.
Tighten hardware securely. See Aligning
the Steering Levers (Figure 11) on
page 22.
6. Battery - Remove battery from unit and
charge (See Battery on page 20).
7. Check Engine Crankcase - Check and
add oil if needed. See Engine Manual for
specifications.
8. Fill fuel tank. DO NOT OVERFILL! See
Filling Fuel Tank on page 14
IMPORTANT: Refer to Engine Manual for fuel
type.
9. Hardware - Check for loose hardware.
10. Check Safety Interlock System - Check
to see that the interlock system operates
correctly (See Safety Interlock System
on page 12).

ASSEMBLY

WARNING: FAILURE OF
INTERLOCK together with improper
operation can result in severe
personal injury.
11. Lubrication - Lubricate all fittings per
maintenance label under seat and check
hydrostat oil level (See Lubricate Unit on
page 21).
12. Level Deck - Check unit to ensure deck
level set at factory has been maintained
(See Leveling the Mower Deck on
page 27).
13. Check Function of all Controls - Ensure
unit runs and performs properly.
1
1. Steering
2. Seat
GB - 10
WARNING: FAILURE OF
CONTROLS could result in death
or serious injury.
2
4
3
Levers
Figure 3
1
3. Mounting
Hardware
4. Cable