Table of Contents
Advertisement
GENERAL INFORMATION
1. Check crate for possible damage sustained during transit.
Carefully remove unit from crate and again check for
damage. Any damage to the appliance must be reported
to the carrier immediately.
2. The wires for retaining the burners and other packing
material must be removed from units. Any protective
material covering stainless steel parts must also be
removed.
3. All equipment is shipped from the factory with legs
fi tted, unless otherwise specifi ed. Where the range is to
be mounted on a dais or cove base, it is shipped without
legs. Legs must be fi tted to the oven where it is installed
on a combustible fl oor.
STATUTORY REGULATIONS
The installation of this appliance must be carried out by
a competent person and in accordance with the relevant
regulations, codes of practice and the related publications of
the country and destination.
The installation must conform to the National Fuel Gas Code
ANSI Z223.1-latest edition, NFPA No. 54 – latest edition and
National Electrical Code ANSI/NFPA 70-latest edition and/or
local code to assure safe and effi cient operation. In Canada,
the installation must comply with CSA B149.1 and local
codes where applicable.
Part # 4515576 Rev 1 (01/21/10)
4. The type of gas and supply pressure that the equipment
was set-up for at the factory is noted on the data plate
and on the packaging. This type of gas supply must be
used.
5. Garland/U.S. Range products are not approved or
authorized for home or residential use, but are intended
for commercial applications only. Garland / U.S. Range
will not provide service, warranty, maintenance
or support of any kind other than in commercial
applications.
6. Do not remove permanently affi xed labels, warnings or
data plates from the appliance, for this may invalidate the
manufacturer's warranty.
In Canada, electrical connections must comply with
applicable sections of the Canadian Electrical Code, C22.1 -
latest edition.
Page 5
Advertisement
Table of Contents
