Replacing The Aquaclean Filter - Saeco Intelia Deluxe User Manual

English
12
ON
A Q U A
CLEAN
OFF
0/8

Replacing the AquaClean filter

Display icon AquaClean filter
10% + icon flashes
0% + icon flashes
0% and icon disappears from display
3 Remove the water tank from the machine.
4 Insert the AquaClean filter vertically onto the filter connection. Push the
AquaClean filter to the lowest possible point. Make sure that the filter fits
tightly and the seal is in the right position, to guarantee the best
performance.
5 Fill the water tank with fresh water and slide it back into the machine.
6 Press the MENU button and scroll to the AquaClean filter option. Then
press the OK button to select the AquaClean filter option.
Note: If you are installing the filter at first time use, follow the steps in
chapter 'First installation'.
7 Select ON on the display and confirm the activation by pressing the OK
button.
Note: The display shows a tick icon to confirm the activation.
8 To rinse the filter, press the SPECIAL DRINKS button, select the HOT
WATER option and press the OK button twice. Water flows out from the
hot water dispensing spout. Discard this water.
Note: It can take a while until water comes out of the hot water
dispensing spout. The filter needs to be fully filled and rinsed with water.
9 Use the sticker attached to the plastic packaging of the AquaClean filter
to write down the date of the next filter replacement (after 3 months).
Place the sticker on the water tank.
The filter and machine are now ready for use.
Replace the filter every 3 months or at machine request.
What to do
The performance of this filter is decreasing. It is
recommended to remove the old filter and place the
new filter as described in section 'AquaClean filter
installation' to retain proper filter performance.
Remove the old filter immediately and place the new
filter as described in section 'AquaClean filter
installation'. When you activate a new filter, the display
shows the word NEW. Press the OK button to confirm
the activation.
You first need to descale the machine before you can
place and activate a new filter.
After 8 filter replacements you need to descale the machine chapter
'Descaling', section 'Descaling procedure'.