Table of Contents
Advertisement
MC-CG973-00
4 SERVICE PROCEDURES - CANISTER
4.1.
HOOD
4.1.1.
Removal
1. Lift up on the hood release as the hood is raised.
2. With the hood all the way up, force it until the two ends pop
out of place.
4.1.2.
Replacement
1. Place each end of the hood into the slot while holding
upright in the position it was removed.
2. Work both ends into the openings and close.
4.2.
CANOPY COVER
4.2.1.
Removal
1. Remove the cord rewind bar by snapping it off from rear to
front.
2. The canopy cover has a screw on each of the four (4)
corners sercuring it in place. Use a screwdriver to remove
each screw.
3. Lift the canopy cover off of the canister base.
4. Secure the power cord to prevent retracting as you are
servicing the motor.
4.2.2.
Replacement
1. Set the canopy cover in position and secure the canopy
with (4) screw holes.
2. Snap the cord rewind bar into place on the canopy cover.
4.3.
CORD REEL
4.3.1.
Removal
1. Remove hood (see HOOD Removal).
2. Remove canopy cover (see CANOPY COVER Removal).
3. Disconnect both cord reel wires.
4. Remove the cord cover cap from the base.
5. Lift the cord reel straight up to remove. Do this by prying it
out of the retainers.
4.3.2.
Replacement
1. Connect both wire cord reel wires to the new cord reel
assembly.
2. Route the plug through the hole in the canister base and
snap the cord cover cap in place.
3. Position the slots in the cord reel brackets into place over
the retainers in the base.
4. Route the cord reel wire into the provided slot to prevent
pinching
5. Replace canopy cover and brake pedal (see Canopy Cover
Replacement.
6. Replace hood (see Hood Replacement).
4.4.
CANISTER MOTOR
4.4.1.
Removal
1. Remove hood (see HOOD Removal).
2. Remove canopy cover (see CANOPY COVER Removal).
3. Remove the motor enclosure from the motor.
14
Hide quick links:
Advertisement
Table of Contents
