HELP15
1.
Install the focus brush so that the tips of it contact to the focus flex patterns, and apply adhesive bond (B-10) to the two screws and
then tighten them as shown in the figure.
Adhesive bond (B-10): J-6082-612-A
2.
Perform the "4-7. Focus Brush Position/Pattern Check".
Focus Brush
Apply adhesive bond (B-10) (Two screws)
HELP16
1.
Apply grease (G-15) to the instruction portions of the zoom ring.
Grease (G-15): J-6082-619-A
Apply grease (G-15) (all circumference)
2.
Turn the zoom ring to align the hole of the zoom ring with the screw hole of the zoom stopper as shown in the figure.
Zoom Stopper
SAL1118 (4.5-5.6/11-18) (DT 11-18mm F4.5-5.6)
Zoom Ring
Hole
HELP