HELP07
Attach the main pcb assy, and fix it with two screws as shown in the figure.
Note:
Be careful not to tighten the two screws too much.
HELP08
Note:
About the insulating tape in the sentence. When shipping it, Mending tape (2-886-794-01) is used.
1.
Set the focus gear barrel to the over infinity position (infinity end) while maintaining the support barrel assy so as not to rotate it.
2.
Affix the two insulating tapes.
3.
Perform "4-4-3. Focus-shift Adjustment".
Support Barrel Assy
Focus Gear Barrel
SAL1118 (4.5-5.6/11-18) (DT 11-18mm F4.5-5.6)
Screws
Main Pcb Assy
Insulating Tape (Two areas)
HELP