Checking The Protectier 3958 Dd6 Firmware Version - IBM TS7650G User Manual

3. Click Done. The Uninstall ProtecTIER Manager wizard closes.

Checking the ProtecTIER 3958 DD6 Firmware version

Complete this task to check the 3958 DD6 Firmware version
About this task
Important: The firmware upgrade process connects to the Baseboard Management
Controller (BMC) to get firmware information. Therefore, it is mandatory to have
the BMC configured with an IP address on the same customer network segment
before continuing with the procedure.
Procedure
1. If you are updating a single node configuration, connect a USB keyboard and
2. If you are updating a clustered configuration, verify that both Server A and
3. At the localhost Login prompt, type the user ID ptconfig and the password
4. Select Protectier Configuration. Type the corresponding number and press
graphics-capable monitor to the server.
Server B are running:
v Yes, continue to step 3
v No, power on any servers that are not running, wait for the boot cycle to
complete, and then continue to step 3
ptconfig press <enter>.
The ProtecTIER System Menu displays:
------------------------------------------------------------------------------
ProtecTIER Service Menu running on rassmx
------------------------------------------------------------------------------
1) ProtecTIER Configuration (...)
2) Manage ProtecTIER services (...)
3) Health Monitoring (...)
4) Problem Alerting (...)
5) Version Information (...)
6) Generate a service report
7) Generate a system view
8) Update ProtecTIER code
9) ProtecTIER Analysis (...)
E) Exit
------------------------------------------------------------------------------
>>> Your choice?
<enter>.
The ProtecTIER Configuration (...) screen displays:
Chapter 4. Installing ProtecTIER Manager
29