Replacing The Processor - Siemens SIMATIC IPC677D Operating Instructions Manual

Maintaining and servicing your device
7.7 Removing and installing hardware
7.7.8

Replacing the processor

Requirement
● The device is opened.
● The memory modules have been removed.
● The air guide has been removed (see chapter "Removing and installing the device fan
(Page 99)")
● A suitable processor
Only an approved processor is permitted to be installed on the motherboard of the
device. If the processor type is changed, the BIOS must be updated so that the suitable
microcode is loaded. Information about original spare parts for SIMATIC IPCs is available
on the Internet at:
– Contacts (http://www.siemens.com/automation/partner)
– SIMATIC IPC after-sales information system (http://www.siemens.com/asis)
Procedure
1. Loosen the screws
The fourth screw is hidden by the air guide in the figure.
2. Remove the heat sink.
3. Release the lever
the processor.
100
①
.
②
of the processor bay and tilt it all the way back. The bay releases
Operating Instructions, 09/2014, A5E32995420-AC
SIMATIC IPC677D