Avoiding Subject Blurring (Intelligent Iso); Taking Close-Up Pictures (Macro Mode); Taking Motion Pictures; Aspect And Picture Quality - Panasonic Lumix DMC-TZ3 Operating Instructions Manual

Panasonic digital camera user manual
Table of Contents

Advertisement

Takiing motion piictures
Detects movement of the subject and sets the optimum ISO sensitivity and shutter speed
according to the brightness.
Set to _
i_f_,_'
lilllFor moving
subjects
indoors,,,
sensitivity and shutter speed raised to
avoid subject blurring.
Take a picture (P.24)
IIFor
stationary
subjects
indoors,,,
sensitivity
lowered to avoid interference.
@The maximum level for ISO sensitivity can also be set (P.5t, 'lSO LIMIT'). If the
maximum level is set to '800' or '1250', this will be reduced to '640' when using the
flash.
@Subject movement may not be detected if subject is too small, is at the edge of the
screen, or starts to move at the same time as the shutter. (when button is pressed fully).
@Blurring may occur depending on the brightness and movement speed.
@'D.ZOOM' (R27) and 'SLOW SHUTTER' (P.56) cannot be used.
ImFocus range in
Intelligent
ISO mode,
MACRO
mode
Max W: Distance of at W%_</_t_TMax T: Distance of at least 1
least 5 cm (0.16 feet)
_
_feet)
from subject
from subject
(_._
displayed)
lever/_
(2 m (6.56 feet) unless max. T)
Zoom
Set to _
Take a picture (P.24)
@We recommend
using a tripod, the self-timer (P.35), and flash 'FORCED OFF' (R36).
@Moving the camera after aligning the focus is likely to result in poorly focused pictures if
subject is close to camera, due to margin for focus alignment
being severely reduced.
@Resolution may be reduced around the edges of the picture.
IITaking
close-up
pictures
from more
distant
locations
(Tele Macro function)
Zoom to max. T to take close-up pictures of flowers at foot-level, or animals that you
cannot approach, from distances of at least 1 m (3.28 feet). Align focus after zooming
by pressing shutter halfway. Using tripod is recommended
as jitter occurs easily.
6
VQT1B61
Record motion pictures and sound (motion pictures cannot be recorded without sound).
Microphone
Set
to B
(voice recording)
Start recording
Press halfway
(align focus)
Press fully
Finish
IIEstimated
recording
time
_, (P.92)
Press fully
@Zoom and CONT.AF (P.55)
functions cannot be used during
IIAspect
and picture
quality
Available recording time
(approx.)
Elapsed time
movie recording.
@Not compatible with
MultiMediaCards.
@STABILIZER
'MODE2' cannot
be used.
@Focus range is 5 cm (0.16 feet)
and above for max. W/1 m (3.28
feet) and above for max. T. (2 m
(656 feet) unless max T)
@Focus, zoom, and aperture
value are fixed from the onset of
recording.
@A maximum of approx. 2 GB can
be recorded in any one session.
To continue recording, press the
shutter button again. Available
recording time is calculated
on a
2 GB basis (estimated).
@ Recording may be terminated
midway, depending on card
type.
@Ends automatically
if memory
is full.
Set 'ASPECT RATIO' (P.51) before 'PICT.MODE'
Picture size
Frames/sec
30/sec
640x480
10/sec
30/sec
320×240
10/sec
30/sec
848×480
10/sec
(R52).
ASPECT
PICT.MODE
30fps VGA _€"
10fps VGA
4:3
30fps QVGA
10fps QVGA
For e-mail
attachments)
30fps 16:9"
16:9
10fps 16:9
'30fps': for smooth picture movement
'10fps': for longer motion pictures
* We recommend
using a card of at least IOMB/s
(as marked on its packaging, etc).
@Only QVGA-format
motion pictures can be
recorded to the built-in memory.
VQT1B61
47

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lumix dmc-tz2

Table of Contents