Panasonic FZ-Y1 series Operating Instructions Manual page 22

Troubleshooting (Basic)
■
Starting Up
The date and time are
incorrect.
[Executing Battery
Recalibration] screen
appears.
[Enter Password]
does not appear when
resuming from sleep/
hibernation.
Cannot resume.
Other startup problems.
22
●
Make the correct settings.
Open the Control Panel.
1. Perform either of the following procedures.
●
Long touch
●
Flick from the middle of the Start screen to the top.
2. Touch [Control Panel].
Touch [Clock, Language, and Region] - [Date and Time].
●
If the problem persists, the internal clock battery may need to be
replaced. Contact Panasonic Technical Support (è page 33 - 39).
●
When the computer is connected to LAN, check the date and time of
the server.
●
The 2100 A.D. or later year will not be correctly recognized on this computer.
●
The Battery Recalibration was canceled before Windows was shut
down last time. To start up Windows, turn off the computer by the
power switch, and then turn on.
●
Select [Enabled] in [Password On Resume] in the [Security] menu of
the Setup Utility (è
●
The Windows password can be used instead of the password set in
the Setup Utility.
Add a password.
1. Display "Charm" and touch
2. Touch [Sign-in options], and touch [Add] under "Password".
Set up the following.
1. Open the Control Panel, and then touch [System and Security] -
[Power Options] - [Require a password when the computer wakes].
2. Touch [Change settings that are currently unavailable] under
"Define power buttons and turn on password protection".
3. Add a check mark for [Require a password].
●
One of the following operations may have been carried out. Press the
power switch to turn on the computer. Data not saved will be lost.
•
In sleep mode, the AC adaptor was disconnected, or a peripheral
was connected or disconnected.
•
The power switch was pressed for 4 seconds or longer to forcibly turn
off the computer.
●
An error may occur when the computer automatically enters the sleep
or hibernation mode while the screensaver is active. In this case, turn
off the screensaver or change the pattern of the screensaver.
●
Start the Setup Utility (è
return the Setup Utility settings (excluding the passwords) to the
default values. Start the Setup Utility and make the settings again.
●
Remove all peripheral devices.
●
Check to see if there was a disk error.
Remove all peripheral devices including an external display.
Perform either of the following procedures.
●
Long touch
●
Flick from the middle of the Start screen to the top.
Touch [File Explorer].
Long touch [Windows (C:)], and touch [Properties].
Touch [Tools] - [Check].
Follow the on-screen instructions.
at the bottom left corner of the desktop screen.
Reference Manual "Setup Utility").
- [Change PC settings] - [Accounts].
Reference Manual "Setup Utility") to
at the bottom left corner of the desktop screen.