Linksys LAPAC2600 User Manual page 20

Location
SNMP v1/v2 Settings
Get Community
Set Community
SNMP v3 Settings
SNMP v3 Settings
Access Control
Access Control
SNMP Trap
Trap Community
Trap Destination
Enter the area or location where the access point
resides.
The location includes 1 to 32 characters. Special
characters are allowed.
Enter the name of Get Community. Get Community is
used to read data from the access point and not for
writing data into the access point.
Get Community includes 1 to 32 characters. Special
characters are allowed.
Enter the name of Set Community. Set Community is
used to write data into the access point.
The Set Community includes 1 to 32 characters.
Special characters are allowed.
Configure the SNMPv3 settings if you want to use
SNMPv3.
Username: Enter the username. It includes 0 to 32
characters. Special characters are allowed.
Authentication Protocol: None or HMAC-MD5.
Authentication Key: 8 to 32 characters. Special
characters are allowed.
Privacy Protocol: None or CBC-DES.
Privacy Key: 8 to 32 characters. Special characters are
allowed.
When SNMP is enabled, any IP address can connect to
the access point MIB database through SNMP. You can
enable access control to allow specified IP addresses.
Two IPv4 and two IPv6 addresses can be specified.
Enter the Trap Community server. It includes 1 to 32
characters. Special characters are allowed.
Two Trap Community servers are supported: can be
IPv4 or IPv6.
20