Toro Greensmaster 3150 Service Manual page 263

Bearing Installation
1. Install new bearings in both side plate assemblies
(Fig. 13):
A. Slide new bearings into non–drive side plates.
Position extended inner race of bearings toward cen-
ter of side plate housing.
B. Press new bearings into drive side plates apply-
ing pressure to outer bearing race only. Position ex-
tended inner race of bearings toward center of side
plate housing.
C. Install new seals into side plates. Note: Seals
should be installed so the lip side of the seal will face
the center of the cutting reel. When bearings are
greased, grease will purge from inner seals.
2. Install non–drive groomer side plate to cutting unit:
A. Position non–drive groomer side plate to cutting
unit making sure that groomer arm lift rod is posi-
tioned through bushing in side plate.
B. Apply antisieze lubricant to threads of lift arm as-
sembly stud. Place spring washer and lock nut on lift
rod threads (Fig. 15). Tighten lock nut.
C. Position motor mount to groomer side plate (Fig.
14). Secure motor mount and groomer side plate to
cutting unit with two (2) socket head screws and lock
nuts.
D. Install hydraulic reel motor to cutting unit (see Hy-
draulic Reel Motor Installation in the Service and Re-
pairs section of Chapter 10 – DPA Cutting Units).
3. Install groomer reel and drive side groomer side
plate (see Groomer Reel Installation in this section).
4. Lubricate groomer bearings (see Groomer Reel Kit
Installation Instructions).
Note: After greasing groomer bearings, operate
groomer for 30 seconds, stop machine and wipe excess
grease from groomer shaft and seals.
5. Check and adjust groomer reel height and mower
height–of–cut settings.
Greensmaster 3150
1
1. Socket head screw
2. Motor mount
3. Groomer side plate (RH)
1. LH groomer side plate
2. Lock nut/spring washer
Page 10.1 – 13 Groomer (DPA Cutting Unit) (Rev. A)
2
3
5
Figure 14
4. Cutting unit
5. Lock nut (2 used)
1
2
Figure 15
3. LH groomer arm
4
3