Releasing The Limiters; Resetting The Limiters - Panasonic AW- PH350 Operating Instructions Manual

Limiters

$Releasing the limiters

A limiter position which has been set can
be released by following the steps
below.
OReleasing the upper limit position
setting of the travel range
1. While holding down the OK button on
the controller, press TRACING/PRESET
MEMORY button 47 .
2. The setting is released when the lamp
of the TRACING/PRESET MEMORY
button 50 [LIMIT OFF] comes on.
OCanceling the lower limit position
setting of the travel range
1. While holding down the OK button on
the controller, press TRACING/PRESET
MEMORY button 46 .
2. The setting is released when the lamp
of the TRACING/PRESET MEMORY
button 50 [LIMIT OFF] comes on.
OCanceling the left-most limit position
setting of the travel range
1. While holding down the OK button on
the controller, press TRACING/PRESET
MEMORY button 44
2. The setting is released when the lamp
of the TRACING/PRESET MEMORY
button 50 [LIMIT OFF] comes on.
OCanceling the right-most limit
position setting of the travel range
1. While holding down the OK button on
the controller, press TRACING/PRESET
MEMORY button 45
2. The setting is released when the lamp
of the TRACING/PRESET MEMORY
button 50 [LIMIT OFF] comes on.
.
.
31

$Resetting the limiters

The same series of operations are
performed either for setting the limiters
or for releasing them: these steps serve
to set the limiters once they have been
released or release the limiters once
they have been set.
To reset the limiters, release the
currently established settings, and set
the limiters again.
The limiter positions which have been
set can be set at different positions by
following the steps below.
1. Follow the steps in "Releasing the
limiters" to release the settings of the
limiter positions which are to be set
again.
2. Follow the steps in "Setting the
limiters" to set the limiter positions.