Filters - Zanussi ZDM17301WA User Manual

CARE AND CLEANING
MAINTENANCE
WARNING! Before maintenance,
deactivate the appliance and
disconnect the mains plug from the
mains socket.
CAUTION! Do not use the appliance
without filters.
Make sure that the filters are correctly
positioned. An incorrect positioning of
the filters will cause bad washing
results and damage to the appliance.
Dirty filters and a clogged spray arm
decrease the washing results.
Regularly check and if necessary,
clean the filters.
REMOVING AND CLEANING THE FILTERS
The filter consists of three parts.
A. Coarse filter
B. Fine filter
C. Main filter
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
If the appliance does not start or it stops during
operation, before you contact an Authorised
A
B
C
1. Turn the fine filter (B) counterclockwise and
remove the filter assembly.
2. Remove the coarse filter (A) by pulling it out
from the fine filter (B).
3. Fully wash the filters with water and a brush.
4. Put the coarse filter (A) into the fine filter (B).
5. Put the filter assembly into the tub and turn the
fine filter (B) clockwise until it locks.
TO CLEAN THE SPRAY ARM
Do not remove the spray arm. If the holes in the
spray arm are clogged, remove remaining parts of
soil with a thin pointed object.
TO CLEAN THE EXTERNAL SURFACES
Clean the external surfaces of the appliance and
the control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive cleaning
pads or solvents (e.g. acetone).
PROTECTING AGAINST FROST
Protect the appliance from frost, for example in
winter. After each cycle:
1. Disconnect the appliance from the electrical
supply.
2. Shut off water supply and disconnect the water
inlet pipe from the water valve.
3. Drain water from the inlet pipe and water valve.
4. Connect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and
use a sponge to collect water from the sump.
Service Centre, check if you can solve the problem
by yourself with the help of the information in the
table.
With some problems programme indicators flash
intermittently indicating a malfunction.
11