Battery Precautions - Panasonic TX-76DT30A Operating Instructions Manual

Getting Started
Battery Replacement and Installation

Battery Precautions

Do Not use rechargeable batteries. Differences in size and performance may cause
incorrect operation.
Do Not mix battery types (Alkaline with zinc-carbon etc.)
Do Not mix old and new batteries. Replace both batteries at the same time.
Do Not attempt to recharge batteries.
Do Not short circuit batteries.
Do Not disassemble batteries.
Do Not heat or burn batteries.
Connect the Power Plug
This television is designed for the Australian Standard Mains Voltage of 240V 50Hz.
NOTE:
If the television is not going to be used for an extended period, remove the power plug from the wall
outlet.
Turn on the Television
Push the Power Switch to turn the television ON. Sit back and enjoy your new Panasonic television.
Power Switch
If the television is not going to be used for a while, turn it off with the power switch. This will reduce the
amount of electricity used, reduce greenhouse emissions and save you money.
6
Place your thumb on triangle on the battery cover. Apply a
slight downward pressure with the thumb and slide the cover
back. This allows the cover to be removed.
Insert the batteries ensuring the correct polarity. The polarity is
identified by the " + " and " – " symbols on the battery and the "
+ " and "– " symbols on the battery compartment. The springs
inside the battery compartment connect to the negative
terminal of the battery.
Two "AA" size batteries
Fit the battery cover and slide it forward until it "clicks" into
place.