Vcr Installation - Panasonic TX-76DT30A Operating Instructions Manual

VCR Installation

Your new TV is supplied with programme position '0' set to receive an RF signal from your VCR, although
an AV connection is preferable. Please refer to page 40 for AV connections.
However, if for some reason your VCR is tuned to a different RF channel then you will not receive any
picture or sound from your VCR on programme position '0' of the TV. It will be necessary to either adjust
the RF channel of your VCR (some VCR's allow adjustment of their RF channel via their remote control
unit) or to adjust the tuning of the TV's programme position '0' or both until it receives the RF output
channel of your VCR.
It is intended that this advice be used in conjunction with the instruction books for your additional
equipment
Use the AV2 Scart terminal for a standard VCR or an S-Video VCR or a Q-Link (or compatible) VCR.
To tune your TV to the VCR
Switch on the VCR, Insert and play a
pre-recorded tape with known content
On the TV, select programme position '0'
Open the Front panel flap.
Press the F button repeatedly until
'Tuning mode" is reached.
Press the - or + button to access Tuning
mode.
Press - or + to begin searching for the
VCR playback.
When the VCR playback Is found, press
the STR button to store the programme
position
The programme position and channel number indicators will flash to indicate the station is being stored.
To exit Manual Tuning, press the F button.
Note:
If picture patterning occurs on programme position '0' it may be necessary to adjust the RF output
Channel of the VCR, refer to your VCR instruction book.
36
F
- / \/ - / \/
- / \/ - / \/
STR
MANUAL TUNE (FRONT PANEL)
- , + : Search
TV/AV : Move cursor
STR : To store
F : To exit
21
STR F -/\/ +//\
68
TV/AV