Pc Connection And Modem - Panasonic TX-76DT30A Operating Instructions Manual

PC Connection and Modem

The PC Connection and Modem menus allow you to make adjustments to the communication settings for
the SERIAL and MODEM ports. You may wish to refer to the operating instruction books for any external
equipment before changing these settings.
Open the Setup menu
Move to DVB setup
Access DVB setup menu
Move to PC Connection or Modem
Access the chosen menu
Make the required adjustments.
('OK' - Store will be flashing)
Press the OK button to store the settings
Press the EXIT button to exit
Baud Rate (bit/sec)
Number of Data Bits
Stop Bits
Protocol
Parity
Dialling
Prefix
Redial attempts
EXIT
Sets the speed of transmission. Use the
highest speed allowed by the external
equipment.
Determines the number of consecutive
data bits to be sent. Select from either 7
or 8.
Determines the number of stop bits to be
used. Select from 1 or 2.
Determines whether a protocol should
be used. Select from None, Hardware or
Software.
Determines whether parity checking
should be used. Select from None, Odd
or Even.
Modem only:
Select either DTMF (Tone) dialing or
Pulse dialing.
Many internal telephone networks
require you to dial a single digit before
dialing an "outside line". If the Modem is
connected to such a system, use the
Prefix function to enter the initial dig it,
for example 0.
The Redial attempts function allows the TV to automatically redial a number if
a connection cannot be made.
(This feature is not currently in use in Australia).
DVB Timer programming
Off timer
DVB timer lock
DVB setup
Teletext
Flicker reduction
Geomagnetic
AV2 out
Tuning menu
DVB - Setup
Signal quality
Common interface module
Favourites setup
Preferred subtitle
System update
Display timeout
PC Connection
Modem
PC Connection
Baud rate (bit/sec)
Number of data bits
Stop bits
Protocol
Parity
Modem
Baud rate (bit/sec)
Number of data bits
Stop bits
Protocol
Parity
Dialling
Prefix
Redial attempts
Select
Access
Exit
Setup menu
Access
Off
Off
Top
On
Analogue
Select
Access
Exit
English
3 seconds
Access
Return
Select
Change
Store
Exit
115200
8
1
None
None
Return
Select
Change
Store
Exit
38400
8
1
None
None
DTMF
None
None
43