Table of Contents
Advertisement
Installation
<Positions and dimensions of mounting holes>
Base connector rear panel side of pan-tilt head
<Ceiling panel: Penetrated hole dimensions>
Hanger
Wire routing hole (reference)
Check the positions and dimensions of the mounting holes, the dimensions of the penetrated hole in
the ceiling panel, and check which is the base connector rear panel side as shown above. Then decide
in which direction the pan-tilt head is to be mounted, and drill the holes for the hangers and for the
penetrated hole in the ceiling panel.
p Provide a hanger that can be coupled with the H steel beam above the ceiling, and attach the
Notes
pan-tilt head to it.
p Be absolutely sure to use the bolts or nuts and flat washers and spring washers for the
installation.
(Be sure to ask your dealer to install the unit.)
113 mm (4-7/16˝)
74 mm
(2-15/16˝)
128 mm (5-1/16˝)
Base connector rear panel side of pan-tilt head
Installation work
4-M6 holes (for mounting the pan-tilt head)
M8 hole (for mounting the underneath
support plate)
82 mm (3-1/4˝)
– 27 –
Drilling the hole in
the ceiling panel
Protruding part
of the underneath
support plate
Advertisement
Table of Contents
