Table of Contents
Advertisement
Installation
<Note>
Before setting the switches, make absolutely sure that the power of the AC adapter
which is to be connected to the pan-tilt head is set to OFF.
(Be sure to ask your dealer to install the unit.)
COMP printed circuit board
CONNECTOR printed circuit board
Installation work
COMP switch
SDI/PR switch
Do not change the setting of this switch
— use it at the PR position.
PB switch
Do not change the setting of this switch
— use it at the PB position.
WEB/1394 switch
Do not change the setting of the
WEB/1394 switch.
Use it at the 1394 position.
WEB/RP 422 switch
Do not change the setting of the
WEB/RP 422 switch.
Use it at the RP 422 position.
– 15 –
Advertisement
Table of Contents
