JVC KS-FX202 Service Manual page 10

KS-FX202
Removing the Flywheel (BF) and (BR)
assembly (See Fig.4 and 5)
Prior to performing the following procedure, remove
the cassette hanger / cassette holder.
1. From the upper side of the cassette mechanism
assembly, remove the C washer from each shaft of
the flywheel (BF) and (BR).
2. Turn over the cassette mechanism assembly and
remove the main belt. Pull out the flywheel (BF) and
(BR) downward respectively.
Removing the reel base assembly
1. Raise the part k of the reel base assembly slightly
and remove the selector link (B) on the front side of
the cassette mechanism assembly by turning it as
shown in Fig.10.
2. Remove the three screws E and the one screw F
on the underside of the cassette mechanism
assembly.
The reel base assembly is not
ATTENTION:
repairable. Handle with care.
Inside of the reel base assembly
1-10
(See Fig.5 and 6)
Fig.7
C washer
C washer
Fig.4
Main-belt
Flywheel (BF)
E
E
Reel base assembly
Flywheel (BR)
Fig.5
k
Selector link (B).
Fig.6
Reel disc assembly
Motor assembly
Sub-belt
G
Motor pulley
G
Soldering j
E
F
Pinch-roller (R) assembly
Turn the selector link (B).