Network Setup - Panasonic WJ-HD500 Operating Instructions Manual

Stop Bit
This item lets you set the number of stop bits for RS-232C
communication.
1. Move the cursor to the STOP BIT parameter by press-
ing the D or C button.
2. Select either 1 or 2 for the number of stop bits by press-
ing the + or - button.
The factory default setting is 1 bit.
Wait Time
This item lets you set the waiting time in milli-seconds (ms)
to retry after confirming that no data is received from the
controller for RS-232C communication.
1. Move the cursor to the WAIT TIME parameter by press-
ing the D or C button.
2. Select OFF, 100, 200, 400, 1 000 ms for the wait time by
pressing the + or - button.
When no transmission is needed, select OFF.
The factory default setting is OFF (no retry).
Flow Control
This item lets you enable or disable the flow control for RS-
232C communication.
1. Move the cursor to the X ON/X OFF parameter by
pressing the D or C button.
2. Select either mode by pressing the + or - button.
NOT USE: Disables flow control with X ON/X OFF code.
USE: Enables flow control with X ON/X OFF code.
The factory default setting is NOT USE.
64

Network Setup

When the optional Network Interface Board is installed in
the Disk Recorder, the Disk Recorder can be controlled
from a Client PC via the Ethernet Hub.
These items let you set the parameters for communication
between the 10/100BASE-T port of the Disk Recorder and
outboard device via Ethernet.
1. Move the cursor to IP ADDRESS in the COMMUNICA-
TION SETUP menu by pressing the C or D button,
then press the SET button.
The cursor moves to the right editing area.
2. Select the value for the IP Address by pressing the +
or - button.
3. Move the cursor to the right by pressing the B button,
then select the value for the IP Address by pressing the
+ or - button.
4. Repeat the above steps 2 and 3 until the IP Address is
completed.
5. When the IP Address is completed, press the SET
UP/ESC button to return the cursor to IP ADDRESS in
the menu.
6. Similarly repeat the above steps 1 to 5 to set the
Netmask and Gateway.
7. To return to the previous setup menu, press the SET
UP/ESC button.