Panasonic NV-GS27GCT Operating Instructions Manual page 20

LSQT1039ENG.book 20 ページ ２００６年２月１日 水曜日 午後３時１３分
(10)
(11)
(12)
(13)
Photoshot button [PHOTO SHOT] ¢
(10)
(11) Rewind/review button [6]
(12)
Pause button [;]
(13)
Stop button [∫]
(14) Recording start/stop button
[START/STOP] ¢
Playback button [PLAY 1]
(15)
(16)
Fast forward/cue button [5]
(17) Enter button [ENTER]
¢ means that these buttons function in the same
manner as the corresponding buttons on the
movie camera.
ª Install a button-type battery
Install the button-type battery supplied in the
remote control before using it.
1 While pressing the stopper 1, pull out the
battery holder.
1
2
Set the button-type battery with its (i) mark
facing upward and get the battery holder
back in place.
Caution
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
equipment manufacturer. Discard used
batteries according to manufacturer's
instructions.
20
LSQT1039
Before using
(14)
(15)
(16)
ª
(17)
≥The distance between the remote control and
the camera: Within approx. 5 m
Angle: Approx. 15o up, down, left, and right
ª
If 2 cameras are used simultaneously, set the
-18-
mode for one pair of movie camera and remote
control to [VCR1] and that of the other pair to
[VCR2]. This will prevent interference between
the 2 pairs. (The default setting is [VCR1]. When
the button-type battery is replaced, the setting will
revert to the default [VCR1].)
1
2
[VCR1]:
Press [D] and [∫] simultaneously. 1
[VCR2]:
Press [E] and [∫] simultaneously. 2
Warning
Risk of fire, explosion and burns. Do not
recharge, disassemble, heat above 100 xC
or incinerate. Keep the Button-Type battery
out of the reach of children. Never put
Button-Type battery in mouth. If swallowed
call your doctor.
Remote control usable range
Selecting the remote control mode
Setting on the camera:
Set [SETUP] >> [REMOTE] >> [VCR1] or
[VCR2].
Setting on the remote control:
2 1